Logic 2.3.7

[KurtE]

What I would do in original software was to add measurements… Example maybe see how long a packet took and how long of a delay to the next one…

Example:

You can see the two measurements using the old software. Note: This was mentioned in previous posting as well. I think it might have been: [Your Input Needed] Timing Marker User Interaction (Poll) - #5 by kazink

Note: I also liked back then when you were trying to enter a new measurement or the like, it would try to logically snap to a start or end point near where I have the mouse.

Note: a) was mentioned in previous thread:

Custom HLA - accessing digital signal data from other signals

Hi, I’m looking to write a decoder for a SPI based protocol that has a few OOB signals (a data/control signal being one of them but also a reset and a cs). Is there a way I can use the time of the message (eg the start time) to query the value of another channel to include it in the decode? I’d also like to be able to provide timing context of the messages wrt the digital channels, perhaps there is something to search for an edge in a certain direction from a timestamp too? I’m trying to rev…