Hacking the Boosted Accessory Port

** I tried to upload the captures to this reply but they wouldn’t complete uploading. Is there another way I can send this?

I still have most of the captures that I used!

To preface the captures, there were different frames in the beginning depending on whether the Arduino and CAN Module were powered via USB or through my skateboard battery. Not too sure why this happens, but since I figured the end product will be powered by the battery, those are the frames I should focus on. The first two captures are when the transceiver are powered by USB, and battery.sal is when it is powered via battery.

‘tx after 5.sal’ is the capture of when I transmitted the handshake after 5 seconds of the battery being on.

‘tx after 10.sal’ is the capture of when I transmitted the handshake after 10 seconds of the battery being on.

‘battery.sal’ is the capture of when the power source is solely the battery, and the handshakes are sent almost right after the skateboard and transceiver are turned on.